MODEL INDICATIONS
The following abbreviations are used in this manual for classification of model types.
ii
M/T:
Indicates the manual transaxle, or models equipped with the manual transaxle.
A/T:
Indicates the automatic transaxle, or models equipped with the automatic transaxle.
MFI:
DOHC:
Indicates the multiport fuel injection, or engines equipped with the multi-point injection.
Indicates an engine with the double overhead camshaft, or a model equipped with such
an engine.
Turbo:
Indicates an engine with turbocharger, or a model equipped with such an engine.
Non-Turbo:
FWD:
Indicates an engine without turbocharger, or a model equipped with such and engine.
Indicates the front wheel-drive vehicles.
AWD:
Indicates the all wheel-drive vehicles.
HOW TO READ A CIRCUIT DIAGRAM
N7OZBOOAA
Circuit diagrams are prepared as follows using these
symbols:
NOTE
For specific details concerning the interpretation
of circuit diagrams, refer to the separately bound
Service Manual.
Indicates power take out.
Indicates input/output to/from
Ilp~x+connector.
I\
‘Y-.W
:
A broken line indicates that
these connectors are the same
:’
e
j;/
:,
*
intermediate connectors.
\
The connector symbol
indicates the device
side connector (for an
intermediate connec-
tor, the male side con-
nector) as seen from
the terminal front (the
connector’s
connec-
I
Output
Input/
Input
,
,
I
output
I
Indicates terminal No.
Indicates current flow downward or
t
j
upward as controlled by the control
,._
unit. I
Indicates harness junction where
To Next Page
Loading...
Need help?
General
