Mitsubishi FX3G Series - 6 Examination of System Configuration; Configuration of a Whole System

6 Examination of System Configuration
6.1 Configuration of a Whole System
53
FX3G Series Programmable Controllers
User's Manual - Hardware Edition
1
Introduction
2
Features and Part Names
3
Product Introduction
4
Specifications
5
Version and Peripheral Devices
6
System Configuration
7
Input/Output Nos., Unit Nos.
8
Installation
9
Preparation and Power Supply Wiring
10
Input Wiring
6. Examination of System Configuration
6.1 Configuration of a Whole System
The configuration of a whole system is shown below as an example.
Special
function block
FX2N input/output powered
extension unit
Extension power supply unit
Unit No.0
*2
*1
Extension devices for FX2N/FX3U Series
Main unit
Extension devices for
FX
2N/FX3U Series
Range of devices powered from
main unit
Expansion board
*1 The connector conversion adapter is required to use a special adapter.
*2 Included in the number of units connectable to the main unit when the input extension block
(including the FX
2N-8ER-ES/UL and FX2N-8ER) is used and the extension power supply unit is located
on the upstream side.
6
FX Series terminal block
Configuration of whole system
4
Determination of number of devices to be connected to extension unit/
extension power supply unit
3
Selection of extension cable
Memory cassette
Special
adapters
Input extension
block
Output
extension block
Input extension
block
Connector conversion
adapter
FX3G-40MT/ES
X000 to X027
FX
2N-32ER-ES/UL
X050 to X067
FX2N-16EX-C FX2N-16CCL-M
X070 to X107
Y040 to Y057
FX
2N-16EX
X030 to X047
Y020 to Y037
FX2N-16EYT
-
Y000 to Y017
The range of devices powered from
the FX
2N input/output powered
extension unit or the extension
power supply unit
5
When CC-Link is used Refer to Chapter 19.
Refer to this chapter.
Display module
1
Expansion board/Special adapters/Memory cassette
Display module/Connector conversion adapter
2
Determination of number of
extension devices to be connected
to main unit