6 - 42 6 - 42
MELSEC-Q
6 PROGRAMMING
*1
Setting
value
write
command
Remote
I/O buffer
memory
write
command
FeRAM
backup
command
Set value write_Cancel write request to FeRAM
Setting
value
write
command
FeRAM write completion
FeRAM
backup
command
Normal control_Auto tuning execution
AT
execution
command
Error flag Operation
mode
status
CH1 AT
command
Program control_Auto tuning execution
Program
control AT
execution
*1: Needed when registering the set input range, alert setting, set value and others to
FeRAM.
Write to FeRAM is not needed when using the GX Configurator-TC's initial setting
or writing in the input range, alert setting, set value and others using sequence
program at power-on.
To Next Page
Loading...
