V5A51 -
Transmission
23E-5-16
ASSEMBLY
Caution
D
Never reuse the gasket, O-ring, oil seal, etc. Always
replace with a new one when reassembling.
D
Never use grease other than blue petrolatum jelly
and white Vaseline.
D
Apply ATF to friction components, rotating parts, and
sliding parts before installation. Immerse a new clutch
disc or brake disc in ATF for at least two hours before
assembling them.
D
Never apply sealant or adhesive to gaskets.
D
When replacing a bushing, replace the assembly
which it belongs to.
D
During the work, always use bare hands or vinyl
gloves. Do not use cotton gloves. Use nylon cloth
or paper towels when necessary. Do not use shop
towel.
D
Change the oil in the cooler system.
1. Install a new gasket a n d output shaft support.
Caution
D
Never reuse a gasket.
2. Tighten the eight output shaft support mounting bolts
to the specified torque.
AddedPWEE8920-I
E
Mar. 2000Mitsubishi Motors Corporation
Output shaft
support