V5A51 -
Transmission
23E-5-6
DISASSEMBLY
Caution
D
Because the automatic transmission is manufactured
from high-precision parts, sufficient care must be
taken not to scratch or damage these parts during
disassembly and reassembly.
D
During the work, always use bare hands or vinyl
gloves. Do not use cotton gloves. Use nylon cloth
or paper towels when necessary. Do not use shop
towel.
D
Parts which have been disassembled should all be
cleaned. Metal parts can be cleaned with normal
detergent, but they should be dried completely using
compressed air.
D
Clutch discs, plastic thrust race and rubber parts
should be cleaned with ATF automatic transmission
fluid so that they do not become dirty.
D
If the transmission body has been damaged,
disassemble and clean the cooler system also.
1. Remove the input shaft speed sensor.
2. Remove the output shaft speed sensor.
3. Remove the manual control lever, an d then remove the
park/neutral position switch.
AddedPWEE8920-I
E
Mar. 2000Mitsubishi Motors Corporation
Manual control lever
Park/neutral position
switch