Cleaning and caring for the unit
81Operating instructions
From the red light phase, the unit displays a cleaning reminder. The
unit can continue to be used, but if it is not cleaned, the cleaning
reminder will appear more frequently.
Traffic light phase Explanation
grey Pollution level low
yellow Pollution level medium
orange Pollution level high
Red Pollution limit reached
1. Warning level: Cleaning reminder is displayed each
time the device is started
2. Warning level: Cleaning reminder is displayed after
each end of cooking process
3. Warning level: Cleaning reminder is displayed after
each end of cooking process and acoustic signal sounds
5.1 Preventing corrosion
• Keep the surfaces of the unit clean and with access to air.
• Remove lime, grease, starch and protein deposits from the
surfaces of the unit.
• Remove salt accumulations.
• Only expose parts made from non-rusting steel to brief contact
with highly acidic foods, spices, salts or the like.
• Avoid damaging the stainless steel surface with other metal items,
such as for example steel spatulas or steel wire brushes.
• Avoid contact with iron and steel, such as for example steel wool
and steel spatulas.
• Do not use bleaching or chlorine-containing cleaning agents.
• Clean the contact surfaces with water.
5.2 Remove rust spots
• Remove fresh rust spots immediately with a mild abrasive or fine
sandpaper.
• Always remove rust spots completely.
• Expose treated areas to fresh air for at least 24 hours. During this
time, do not allow any contact with greases, oils or foods so that a
new protective layer can form.
5.3 Cleaning the housing
Requirement Unit switched off and cooled down
Clean the housing with warm water and commercially available
washing-up liquid.
4127003--0ABBE-E
To Next Page
Loading...
