Troubleshooting
91Operating instructions
6.3 Causes of errors and remedies
If a fault occurs during operation, the error number and error
message are displayed.
Fault no. Error message displayed Description Measure to be taken
694
695
• Cooking zone sensor is
defective
The internal core temperature
sensor takes over the function of
the defective cooking zone sensor.
• Insert the internal core temperat-
ure sensor into its holder.
• A different cooking result may oc-
cur.
• Contact Customer service.
699
700
714
716
• Internal core temperature
sensor is defective
The internal core temperature
sensor in the cooking zone is
deactivated.
• If possible, use the external core
temperature sensor (optional).
• Select another cooking program.
• Contact Customer service.
710 • Vapour sensor defective Vapour elimination is now only
controlled by the software. This
results in higher water
consumption.
• Contact Customer service
• Water pressure too low As permanent error message • Open the water valve
• If the water valve is not closed,
contact Customer service
• Water pressure too low As sporadic error message • Activate fewer simultaneous wa-
ter consumers in the kitchen.
• Contact Customer service
• No water in the waste trap The waste trap is not filled with
sufficient water.
• Open the water valve
• 2 l Pour water into the cooking
zone
• If the error message persists,
contact Customer service
• Unit restarted after a
power failure
If there was no power failure in the
kitchen, it could be an operating
error. An example of this would be
unintentional switching on and off
during a running cooking program.
• Power failure < 1 minute
• Confirm the power failure mes-
sage
• Continue with the cooking pro-
gram
• No cleaning necessary
• Power failure > 1 minute
• Cooking program cancelled
• Perform cleaning
• WaveClean cancelled • Please observe the explanations and notes in the chapter on "Automatic
cleaning (WaveClean)"
4127003--0ABBE-E
To Next Page
