Cleaning and caring for the unit
89Operating instructions
5.10.4 Allowing the cleaner to act
Close the cooking zone door.
The acting time starts.
The display shows the remaining time until the "Flush cooking
zone" stage.
5.10.5 Starting cleaning
The acting time has elapsed, the cleaning process starts
automatically.
The cooking zone is heated.
The display shows the remaining time.
5.10.6 Drying the cooking zone
Requirement Cooking his own door closed
1. The drying process starts automatically.
The cooking zone is heated.
2. After the end of the drying process, a signal sounds.
"End" appears on the display.
3. Open the cooking zone door and leave it ajar until the unit is used
again.
This extends the service life of the door seal.
No moisture builds up in the cooking zone.
5.11 Inspecting the unit
5.11.1 Performing a visual inspection
ATTENTION
Risk of physical damage from improper inspection
• Inspect in accordance with the inspection intervals.
• Has inspection performed by a proficient operator.
• In the event of damage or signs of wear, contact Customer
service immediately and do not operate the unit any longer.
Requirement Unit disconnected from power
Unit empty and cleaned
Cooking zone door opened completely
Inspect housing, cooking zone door and cooking zone yearly for
deformation and damage.
Visual inspection has been performed.
4127003--0ABBE-E
To Next Page
Loading...
