Cleaning and caring for the unit
87Operating instructions
5.9.4 Starting automatic cleaning
Never operate the unit in the automatic cleaning mode without a
cleaning cartridge.
Requirements Water connection is open
The unit is on
Cleaning level selected
Cleaning cartridge inserted
Cooking zone temperature at 60 °C
Tap the "START STOPP" button.
The display shows the remaining time.
5.9.5 Cancelling automatic cleaning
1. Tap the "STOPP" button.
Automatic cleaning is cancelled.
Automatic rinsing starts and cannot be cancelled.
Upon completion, a prompt appears to remove the cleaning
cartridge.
2. Remove the cleaning cartridge.
5.9.6 Ending automatic cleaning
CAUTION
Risk of chemical burns
Droplet quantities can contain caustic constituents, so suitable
protective measures must be taken.
Requirement Automatic rinsing has stopped after the cleaning program was
cancelled or the cleaning time has elapsed
1. Open cooking zone door.
2. Remove the empty cleaning cartridge.
3. Use the hand shower to thoroughly rinse out any remaining
cleaner or rinsing agent.
4. Close cooking zone door.
After the cooking zone door is closed, the cleaning program is
completed.
5. Flush away any droplets of cleaning water on the floor in front of
the unit with a soft water jet.
6. Open the cooking zone door and leave it open with a slight gap
until the unit is used again.
This extends the service life of the door seal.
No moisture builds up in the cooking zone.
4127003--0ABBE-E
To Next Page
Loading...
