Chapter 5
| SNMP Commands
General SNMP Commands
– 138 –
General SNMP Commands
snmp-server This command enables the SNMPv3 engine and services for all management clients
(i.e., versions 1, 2c, 3). Use the no form to disable the server.
Syntax
[no] snmp-server
Default Setting
Enabled
Command Mode
Global Configuration
Notification Log Commands
nlm Enables the specified notification log GC
snmp-server notify-filter Creates a notification log and specifies the target host GC
show nlm oper-status Shows operation status of configured notification logs PE
show snmp notify-filter Displays the configured notification logs PE
ATC Trap Commands
snmp-server enable port-
traps atc broadcast-alarm-
clear
Sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been
triggered
IC (Port)
snmp-server enable port-
traps atc broadcast-alarm-
fire
Sends a trap when broadcast traffic exceeds the upper
threshold for automatic storm control
IC (Port)
snmp-server enable port-
traps atc broadcast-control-
apply
Sends a trap when broadcast traffic exceeds the upper
threshold for automatic storm control and the apply timer
expires
IC (Port)
snmp-server enable port-
traps atc broadcast-control-
release
Sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been
triggered and the release timer expires
IC (Port)
snmp-server enable port-
traps atc multicast-alarm-
clear
Sends a trap when multicast traffic falls beneath the lower
threshold after a storm control response has been
triggered
IC (Port)
snmp-server enable port-
traps atc multicast-alarm-
fire
Sends a trap when multicast traffic exceeds the upper
threshold for automatic storm control
IC (Port)
snmp-server enable port-
traps atc multicast-control-
apply
Sends a trap when multicast traffic exceeds the upper
threshold for automatic storm control and the apply timer
expires
IC (Port)
snmp-server enable port-
traps atc multicast-control-
release
Sends a trap when multicast traffic falls beneath the lower
threshold after a storm control response has been
triggered and the release timer expires
IC (Port)
Table 25: SNMP Commands (Continued)
Command Function Mode
To Next Page
Loading...
