Motorola EX-3524 - Cdp (Global Configuration); Cdp Hold-Time

Chapter 22 | CDP Commands
– 518 –
cdp
(Global Configuration)
This command enables CDP globally on the switch. Use the no form to disable CDP.
Syntax
[no] cdp
Default Setting
Disabled
Command Mode
Global Configuration
Example
Console(config)#cdp
Console(config)#
cdp hold-time This command specifies the amount of time the receiving device should hold a CDP
packet sent from this switch. Use the no form to restore the default setting.
Syntax
cdp hold-time seconds
no cdp hold-time
seconds - The hold time sent in CDP update packets.
(Range: 10-255 seconds)
Default Setting
180 seconds
Command Mode
Global Configuration
Example
Console(config)#cdp hold-time 100
Console(config)#