Chapter 3
| General Commands
– 77 –
Example
In this example, the show history command lists the contents of the command
history buffer:
Console#show history
Execution command history:
2 config
1 show history
Configuration command history:
4 interface vlan 1
3 exit
2 interface vlan 1
1 end
Console#
The ! command repeats commands from the Execution command history buffer
when you are in Normal Exec or Privileged Exec Mode, and commands from the
Configuration command history buffer when you are in any of the configuration
modes. In this example, the !2 command repeats the second command in the
Execution history buffer (config).
Console#!2
Console#config
Console(config)#
configure This command activates Global Configuration mode. You must enter this mode to
modify any settings on the switch. You must also enter Global Configuration mode
prior to enabling some of the other configuration modes, such as Interface
Configuration, Line Configuration, and VLAN Database Configuration. See
“Understanding Command Modes” on page 66.
Default Setting
None
Command Mode
Privileged Exec
Example
Console#configure
Console(config)#
Related Commands
end (79)
To Next Page
Loading...
Need help?
General
