Chapter 22
| CDP Commands
– 520 –
cdp
(Interface Configuration)
This command enables CDP on the selected interface. Use the no form to disable
CDP on the selected interface.
Syntax
[no] cdp
Default Setting
Disabled
Command Mode
Interface Configuration
Example
Console(config)#interface ethernet 1/1
Console(config-if)#cdp
Console(config-if)#
clear cdp table This command clears the CDP neighbor table.
Command Mode
Privileged Exec
Command Usage
When a port link goes down, CDP will also clear the peer information for this port.
Example
Console#clear cdp table
Console#
show cdp This command shows the global CDP configuration settings.
Command Mode
Privileged Exec
Example
Console#show cdp
CDP Global Configuration
Status : Disabled
Transmit Interval : 60 seconds
Hold Time : 180 seconds
Version : 2
Console#
To Next Page
Loading...
Need help?
General
