Chapter 9
| Access Control Lists
IPv6 ACLs
– 281 –
This allows packets to any destination address when the DSCP value is 5.
Console(config-ext-ipv6-acl)#permit any dscp 5
Console(config-ext-ipv6-acl)#
This allows any packets sent to the destination 2009:DB9:2229::79/48 when the
next header is 43.”
Console(config-ext-ipv6-acl)#permit 2009:DB9:2229::79/48 next-header 43
Console(config-ext-ipv6-acl)#
Related Commands
access-list ipv6 (277)
Time Range (128)
show ipv6 access-list This command displays the rules for configured IPv6 ACLs.
Syntax
show ipv6 access-list {standard | extended} [acl-name]
standard – Specifies a standard IPv6 ACL.
extended – Specifies an extended IPv6 ACL.
acl-name – Name of the ACL. (Maximum length: 16 characters)
Command Mode
Privileged Exec
Example
Console#show ipv6 access-list standard
IPv6 standard access-list david:
permit host 2009:DB9:2229::79
permit 2009:DB9:2229:5::/64
Console#
Related Commands
permit, deny, redirect-to (Standard IPv6 ACL) (278)
permit, deny, redirect-to (Extended IPv6 ACL) (279)
ipv6 access-group (282)
To Next Page
Loading...
Need help?
General
