Chapter 4
| System Management Commands
System Status
– 83 –
show access-list
tcam-utilization
This command shows utilization parameters for TCAM (Ternary Content
Addressable Memory), including the number policy control entries in use, the
number of free entries, and the overall percentage of TCAM in use.
Command Mode
Privileged Exec
Command Usage
Policy control entries (PCEs) are used by various system functions which rely on
rule-based searches, including Access Control Lists (ACLs), IP Source Guard filter
rules, Quality of Service (QoS) processes, or traps.
For example, when binding an ACL to a port, each rule in an ACL will use two PCEs;
and when setting an IP Source Guard filter rule for a port, the system will also use
two PCEs.
Example
Console#show access-list tcam-utilization
Total Policy Control Entries : 512
Free Policy Control Entries : 352
Entries Used by System : 160
Entries Used by User : 0
TCAM Utilization : 31.25%
Console#
show memory This command shows memory utilization parameters.
Command Mode
Normal Exec, Privileged Exec
Command Usage
This command shows the amount of memory currently free for use, the amount of
memory allocated to active processes, and the total amount of system memory.
Example
Console#show memory
Status Bytes
------ ----------
Free 50917376
Used 83300352
Total 134217728
show users Shows all active console and Telnet sessions, including user
name, idle time, and IP address of Telnet clients
NE, PE
show version Displays version information for the system NE, PE
Table 10: System Status Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General
