Motorola EX-3524 - Mac Access-Group

Chapter 9 | Access Control Lists
MAC ACLs
– 286 –
Command Usage
◆ New rules are added to the end of the list.
◆ The ethertype option can only be used to filter Ethernet II formatted packets.
◆ A detailed listing of Ethernet protocol types can be found in RFC 1060. A few of
the more common types include the following:
■
0800 - IP
■
0806 - ARP
■
8137 - IPX
Example
This rule permits packets from any source MAC address to the destination address
00-e0-29-94-34-de where the Ethernet type is 0800.
Console(config-mac-acl)#permit any host 00-e0-29-94-34-de ethertype 0800
Console(config-mac-acl)#
Related Commands
access-list mac (283)
Time Range (128)
mac access-group This command binds a MAC ACL to a port. Use the no form to remove the port.
Syntax
mac access-group acl-name in [time-range time-range-name]
acl-name – Name of the ACL. (Maximum length: 32 characters)
in – Indicates that this list applies to ingress packets.
time-range-name - Name of the time range. (Range: 1-30 characters)
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
◆ Only one ACL can be bound to a port.
◆ If an ACL is already bound to a port and you bind a different ACL to it, the
switch will replace the old binding with the new one.