Chapter 24
| DHCP Commands
DHCP for IPv6
– 534 –
DHCP for IPv6
ipv6 dhcp client
rapid-commit vlan
This command specifies the Rapid Commit option for DHCPv6 message exchange
for all DHCPv6 client requests submitted from the specified interface. Use the no
form to disable this option.
Syntax
[no] ipv6 dhcp client rapid-commit vlan vlan-id
vlan-id - VLAN ID, specified as a single number, a range of consecutive
numbers separated by a hyphen, or multiple numbers separated by
commas. (Range: 1-4093; Maximum command length: 300 characters)
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
â—† DHCPv6 clients can obtain configuration parameters from a server through a
normal four-message exchange (solicit, advertise, request, reply), or through a
rapid two-message exchange (solicit, reply). The rapid-commit option must be
enabled on both client and server for the two-message exchange to be used.
â—† This command allows two-message exchange method for prefix delegation.
When enabled, DCHPv6 client requests submitted from the specified interface
will include the rapid commit option in all solicit messages.
Example
Console(config)#ipv6 dhcp client rapid-commit vlan 2
Console(config)#
ipv6 dhcp restart
client vlan
This command submits a DHCPv6 client request.
Syntax
ipv6 dhcp restart client vlan vlan-id
vlan-id - VLAN ID, specified as a single number, a range of consecutive
numbers separated by a hyphen, or multiple numbers separated by
commas. (Range: 1-4093; Maximum command length: 300 characters)
Default Setting
None
To Next Page
Loading...
Need help?
General
