Chapter 25
| IP Interface Commands
IPv6 Interface
– 564 –
clear ipv6 traffic This command resets IPv6 traffic counters.
Command Mode
Privileged Exec
Command Usage
This command resets all of the counters displayed by the show ipv6 traffic
command.
Example
Console#clear ipv6 traffic
Console#
destination unreachable
messages
The number of ICMP Destination Unreachable messages sent by the
interface.
packet too big messages The number of ICMP Packet Too Big messages sent by the interface.
time exceeded messages The number of ICMP Time Exceeded messages sent by the interface.
parameter problem
message
The number of ICMP Parameter Problem messages sent by the
interface.
echo request messages The number of ICMP Echo (request) messages sent by the interface.
echo reply messages The number of ICMP Echo Reply messages sent by the interface.
router solicit messages The number of ICMP Router Solicitation messages sent by the interface.
neighbor advertisement
messages
The number of ICMP Router Advertisement messages sent by the
interface.
redirect messages The number of Redirect messages sent. For a host, this object will
always be zero, since hosts do not send redirects.
group membership
response messages
The number of ICMPv6 Group Membership Response messages sent.
group membership
reduction messages
The number of ICMPv6 Group Membership Reduction messages sent.
UDP Statistics
input The total number of UDP datagrams delivered to UDP users.
no port errors The total number of received UDP datagrams for which there was no
application at the destination port.
other errors The number of received UDP datagrams that could not be delivered for
reasons other than the lack of an application at the destination port.
output The total number of UDP datagrams sent from this entity.
Table 124: show ipv6 traffic - display description (Continued)
Field Description
To Next Page
Loading...
