Chapter 3
| General Commands
– 75 –
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆ This command resets the entire system.
◆ Any combination of reload options may be specified. If the same option is re-
specified, the previous setting will be overwritten.
◆ When the system is restarted, it will always run the Power-On Self-Test. It will
also retain all configuration information stored in non-volatile memory by the
copy running-config startup-config command (See “copy” on page 92).
Example
This example shows how to reset the switch after 30 minutes:
Console(config)#reload in minute 30
***
*** --- Rebooting at January 1 02:10:43 2007 ---
***
Are you sure to reboot the system at the specified time? <y/n>
enable This command activates Privileged Exec mode. In privileged mode, additional
commands are available, and certain commands display additional information.
See “Understanding Command Modes” on page 66.
Syntax
enable [level]
level - Privilege level to log into the device.
The device has two predefined privilege levels: 0: Normal Exec,
15: Privileged Exec. Enter level 15 to access Privileged Exec mode.
Default Setting
Level 15
Command Mode
Normal Exec
Command Usage
◆ “super” is the default password required to change the command mode from
Normal Exec to Privileged Exec. (To set this password, see the enable password
command.)
To Next Page
Loading...
Need help?
General
