Chapter 4
| System Management Commands
System Status
– 85 –
snmp-server community private rw
!
snmp-server enable traps authentication
!
username motorola access-level 15
username motorola password 7 21232f297a57a5a743894a0e4a801fc3
username guest access-level 0
username guest password 7 084e0343a0486ff05530df6c705c8bb4
enable password level 15 7 1b3231655cebb7a1f783eddf27d254ca
!
vlan database
vlan 1 name DefaultVlan media ethernet state active
!
spanning-tree mst configuration
!
interface ethernet 1/1
switchport allowed vlan add 1 untagged
switchport native vlan 1
qos map dscp-mutation 6 0 from 46
.
.
.
!
interface vlan 1
ip address 192.168.1.10 255.255.255.0
!
queue mode strict-wrr 0 0 0 1
!
line console
!
line vty
!
end
!
Console#
Related Commands
show startup-config (85)
show startup-config This command displays the configuration file stored in non-volatile memory that is
used to start up the system.
Command Mode
Privileged Exec
Command Usage
◆ Use this command in conjunction with the show running-config command to
compare the information in running memory to the information stored in non-
volatile memory.
◆ This command displays settings for key command modes. Each mode group is
separated by “!” symbols, and includes the configuration mode command, and
corresponding commands. This command displays the following information:
■
MAC address for the switch
■
SNMP community strings
■
SNMP trap authentication
■
RMON alarms settings
To Next Page
Loading...
Need help?
General
