Motorola EX-3524 - Show Power-Save

Chapter 10 | Interface Commands
Power Savings
– 311 –
Note: Power savings can only be implemented on Gigabit Ethernet ports using
twisted-pair cabling. Power-savings mode on a active link only works when
connection speed is 1 Gbps, and line length is less than 60 meters.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#power-save
Console(config-if)#
show power-save This command shows the configuration settings for power savings.
Syntax
show power-save [interface interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-24/48)
Command Mode
Privileged Exec
Example
Console#show power-save interface ethernet 1/4
Power Saving Status:
Ethernet 1/1 : Enabled
Console#