– 573 –
26 IP Routing Commands
After network interfaces are configured for the switch, the paths used to send
traffic between different interfaces must be set. If routing is enabled on the switch,
traffic will automatically be forwarded between all of the local subnetworks.
However, to forward traffic to devices on other subnetworks, either configure fixed
paths with static routing commands, or enable a dynamic routing protocol that
exchanges information with other routers on the network to automatically
determine the best path to any subnetwork.
This section includes commands for both static and dynamic routing. These
commands are used to connect between different local subnetworks or to connect
the router to the enterprise network.
Global Routing Configuration
.
Table 203: IP Routing Commands
Command Group Function
Global Routing Configuration Configures global parameters for static and dynamic routing, displays
the routing table and statistics for protocols used to exchange
routing information
Table 204: Global Routing Configuration Commands
Command Function Mode
ip route Configures static routes GC
show ip route Displays specified entries in the routing table PE
show ip route database Displays static or dynamically learned entries in the routing
table
PE
show ip route summary Displays summary information for the routing table PE
To Next Page
Loading...
Need help?
General
