Chapter 10
| Interface Commands
Interface Configuration
– 304 –
3805 Packet Size 65 to 127 Octets
2448 Packet Size 128 to 255 Octets
797 Packet Size 256 to 511 Octets
2941 Packet Size 512 to 1023 Octets
9187 Packet Size 1024 to 1518 Octets
===== Port Utilization (recent 300 seconds) =====
0 Octets input per second
0 Packets input per second
0.00 % Input utilization
0 Octets output per second
0 Packets output per second
0.00 % Output utilization
Console#
show interfaces status This command displays the status for an interface.
Syntax
show interfaces status [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-12)
vlan vlan-id (Range: 1-4093)
Default Setting
Shows the status for all interfaces.
Command Mode
Normal Exec, Privileged Exec
Command Usage
If no interface is specified, information on all interfaces is displayed.
Example
Console#show interfaces status ethernet 1/21
Information of Eth 1/21
Port Type : 1000T
MAC Address : B4-0E-DC-34-E6-3D
Configuration:
Name :
Port Admin : Up
Speed-Duplex : Auto
Capabilities : 10half, 10full, 100half, 100full, 1000full
Flow Control : Disabled
VLAN Trunking : Disabled
LACP : Disabled
Port Security : Disabled
Max MAC Count : 0
Port Security Action : None
To Next Page
Loading...
Need help?
General
