Motorola EX-3524 - Ipv6 Access-Group; Show Ipv6 Access-Group

Chapter 9 | Access Control Lists
IPv6 ACLs
– 282 –
ipv6 access-group This command binds a port to an IPv6 ACL. Use the no form to remove the port.
Syntax
ipv6 access-group acl-name in [time-range time-range-name]
no ipv6 access-group acl-name in
acl-name – Name of the ACL. (Maximum length: 16 characters)
in – Indicates that this list applies to ingress packets.
time-range-name - Name of the time range.
(Range: 1-30 characters)
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
◆ A port can only be bound to one ACL.
◆ If a port is already bound to an ACL and you bind it to a different ACL, the
switch will replace the old binding with the new one.
◆ IPv6 ACLs can only be applied to ingress packets.
Example
Console(config)#interface ethernet 1/2
Console(config-if)#ipv6 access-group standard david in
Console(config-if)#
Related Commands
show ipv6 access-list (281)
Time Range (128)
show ipv6
access-group
This command shows the ports assigned to IPv6 ACLs.
Command Mode
Privileged Exec
Example
Console#show ipv6 access-group
Interface ethernet 1/2
IPv6 standard access-list david in
Console#