Motorola EX-3524 - Lldp Dot3-Tlv Link-Agg; Lldp Dot3-Tlv Max-Frame

Chapter 21 | LLDP Commands
– 504 –
Command Usage
This option advertises the name of all VLANs to which this interface has been
assigned. See “switchport allowed vlan” on page 403 and “protocol-vlan
protocol-group (Configuring Interfaces)” on page 415.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot1-tlv vlan-name
Console(config-if)#
lldp dot3-tlv link-agg This command configures an LLDP-enabled port to advertise link aggregation
capabilities. Use the no form to disable this feature.
Syntax
[no] lldp dot3-tlv link-agg
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises link aggregation capabilities, aggregation status of the link,
and the 802.3 aggregated port identifier if this interface is currently a link
aggregation member.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot3-tlv link-agg
Console(config-if)#
lldp dot3-tlv
max-frame
This command configures an LLDP-enabled port to advertise its maximum frame
size. Use the no form to disable this feature.
Syntax
[no] lldp dot3-tlv max-frame
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)