Chapter 10
| Interface Commands
Interface Configuration
– 306 –
802.1Q-tunnel TPID : 8100(Hex)
Console#
Table 62: show interfaces switchport - display description
Field Description
Broadcast
Threshold
Shows if broadcast storm suppression is enabled or disabled; if enabled it also
shows the threshold level (page 345).
Multicast Threshold Shows if multicast storm suppression is enabled or disabled; if enabled it also
shows the threshold level (page 345).
Unknown Unicast
Threshold
Shows if unknown unicast storm suppression is enabled or disabled; if enabled
it also shows the threshold level (page 345).
LACP Status Shows if Link Aggregation Control Protocol has been enabled or disabled
(page 315).
Ingress/Egress Rate
Limit
Shows if rate limiting is enabled, and the current rate limit (page 765).
VLAN Membership
Mode
Indicates membership mode as Trunk or Hybrid (page 405).
Ingress Rule Shows if ingress filtering is enabled or disabled (page 404).
Acceptable Frame
Type
Shows if acceptable VLAN frames include all types or tagged frames only
(page 403).
Native VLAN Indicates the default Port VLAN ID (page 406).
Priority for
Untagged Traffic
Indicates the default priority for untagged frames (page 432).
GVRP Status Shows if GARP VLAN Registration Protocol is enabled or disabled (page 397).
Allowed VLAN Shows the VLANs this interface has joined, where “(u)” indicates untagged and
“(t)” indicates tagged (page 403).
Forbidden VLAN Shows the VLANs this interface can not dynamically join via GVRP (page 396).
802.1Q-tunnel
Status
Shows if 802.1Q tunnel is enabled on this interface (page 410).
802.1Q-tunnel
Mode
Shows the tunnel mode as Normal, 802.1Q Tunnel or 802.1Q Tunnel Uplink
(page 412).
802.1Q-tunnel TPID Shows the Tag Protocol Identifier used for learning and switching packets
(page 411).
To Next Page
Loading...
Need help?
General
