Chapter 5
| SNMP Commands
SNMPv3 Commands
– 146 –
Example
Console(config)#snmp-server engine-id local 1234567890
Console(config)#snmp-server engineID remote 9876543210 192.168.1.19
Console(config)#
Related Commands
snmp-server host (142)
snmp-server group This command adds an SNMP group, mapping SNMP users to SNMP views. Use the
no form to remove an SNMP group.
Syntax
snmp-server group groupname
{v1 | v2c | v3 {auth | noauth | priv}}
[read readview] [write writeview] [notify notifyview]
no snmp-server group groupname
groupname - Name of an SNMP group. (Range: 1-32 characters)
v1 | v2c | v3 - Use SNMP version 1, 2c or 3.
auth | noauth | priv - This group uses SNMPv3 with authentication, no
authentication, or with authentication and privacy. See “Simple Network
Management Protocol” in the System Reference Guide for further
information about these authentication and encryption options.
readview - Defines the view for read access. (1-32 characters)
writeview - Defines the view for write access. (1-32 characters)
notifyview - Defines the view for notifications. (1-32 characters)
Default Setting
Default groups: public
1
(read only), private
2
(read/write)
readview - Every object belonging to the Internet OID space (1).
writeview - Nothing is defined.
notifyview - Nothing is defined.
Command Mode
Global Configuration
Command Usage
◆ A group sets the access policy for the assigned users.
◆ When authentication is selected, the MD5 or SHA algorithm is used as specified
in the snmp-server user command.
◆ When privacy is selected, the DES 56-bit algorithm is used for data encryption.
1. No view is defined.
2. Maps to the defaultview.
To Next Page
Loading...
Need help?
General
