Motorola EX-3524 - Power Inline Maximum Allocation

Chapter 12 | Power over Ethernet Commands
– 327 –
Command Mode
Interface Configuration (Ethernet ports 1-24/48)
Command Usage
◆ The switch only provides power to the Fast Ethernet or Gigabit Ethernet
copper-media ports.
◆ When detection is enabled for PoE-compliant devices, power is automatically
supplied when a device is detected on the port, providing that the power
demanded does not exceed the port’s power budget or the switch’s power
budget.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#power inline
Console(config-if)#exit
Console(config)#interface ethernet 1/2
Console(config-if)#no power inline
Console(config-if)#
Related Commands
time-range (128)
power inline
maximum allocation
This command limits the power allocated to specific ports. Use the no form to
restore the default setting.
Syntax
power inline maximum allocation milliwatts
no power inline maximum allocation
milliwatts - The maximum power budget for the port.
(Range: 3000 - 34200 milliwatts)
Default Setting
34200 milliwatts
Command Mode
Interface Configuration (Ethernet ports 1-24/48)
Command Usage
◆ All the RJ-45 ports support the IEEE802.3at-2009 PoE standard. The total PoE
power delivered by all ports cannot exceed the 390/779
7
Watts power budget.
This means that up to 11/22
7
ports can supply a maximum 34.2W of power
simultaneously to connected devices (802.3at), up to 24/48
7
ports can supply
up to 15.4W (802.3af).
7. Values for EX-3524 and EX-3548.