Chapter 18
| Class of Service Commands
Priority Commands (Layer 3 and 4)
– 440 –
5 : (6,0) (6,3) (6,0) (6,1) (6,0) (6,3) (7,0) (7,1) (7,0) (7,3)
6 : (7,0) (7,1) (7,0) (7,3)
Console#
show qos map
phb-queue
This command shows internal per-hop behavior to hardware queue map.
Syntax
show qos map phb-queue
Command Mode
Privileged Exec
Example
Console#show qos map phb-queue
phb-queue map:
phb: 0 1 2 3 4 5 6 7
-------------------------------------------------------
Queue: 1 0 0 1 2 2 3 3
Console#
show qos map
trust-mode
This command shows the QoS mapping mode.
Syntax
show qos map trust-mode interface interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-12)
Command Mode
Privileged Exec
Example
The following shows that the trust mode is set to CoS:
Console#show qos map trust-mode interface ethernet 1/5
Information of Eth 1/5
COS map mode: cos mode
Console#