Motorola EX-3524 - Interface; Interface Commands; Interface Configuration

Chapter 10 | Interface Commands
Interface Configuration
– 294 –
Interface Configuration
interface This command configures an interface type and enters interface configuration
mode. Use the no form with a trunk to remove an inactive interface.
Syntax
[no] interface interface-list
interface-list – One or more ports. Use a hyphen to indicate a
consecutive
list of ports or a comma between non-consecutive ports.
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-12)
vlan vlan-id (Range: 1-4093)
Default Setting
None
Command Mode
Global Configuration
Example
To specify several different ports, enter the following command:
Console(config)#interface ethernet 1/17-20,23
Console(config-if)#shutdown
Power Savings
power-save Enables power savings mode on the specified port IC
show power-save Shows the configuration settings for power savings PE
Table 61: Interface Commands (Continued)
Command Function Mode