Motorola EX-3524 - Page 71

Chapter 2 | Using the Command Line Interface
CLI Command Groups
– 71 –
The access mode shown in the following tables is indicated by these abbreviations:
ACL (Access Control List Configuration)
CM (Class Map Configuration)
GC (Global Configuration)
IC (Interface Configuration)
IPC (IGMP Profile Configuration)
LC (Line Configuration)
MST (Multiple Spanning Tree)
NE (Normal Exec)
PE (Privileged Exec)
PM (Policy Map Configuration)
VC (VLAN Database Configuration)
VLANs Configures VLAN settings, and defines port membership for
VLAN groups; also enables or configures private VLANs,
protocol VLANs, voice VLANs, and QinQ tunneling
393
Class of Service Sets port priority for untagged frames, selects strict priority or
weighted round robin, relative weight for each priority queue,
also sets priority for DSCP
429
Quality of Service Configures Differentiated Services 441
Multicast Filtering Configures IGMP multicast filtering, query, profile, and proxy
parameters; specifies ports attached to a multicast router; also
configures multicast VLAN registration
459
Link Layer Discovery
Protocol
Configures LLDP settings to enable information discovery
about neighbor devices
493
Cisco Discovery Protocol Configures CDP settings to enable information discovery
about neighbor devices
517
Domain Name Service Configures DNS services. 523
Dynamic Host
Configuration Protocol
Configures DHCP client functions 531
IP Interface Configures IP address for the switch interfaces; also
configures ARP parameters and static entries
537
IP Routing Configures static unicast routing 573
Table 6: Command Group Index (Continued)
Command Group Description Page