10 Rev. 01/2015
2.1 General Safety Instructions
The following safety instructions must be followed in the area in which the device is operated.
High voltage! Danger to life!
While the engine is running, the area around the ignition system especially
holds the risk of danger due to high voltage. The following parts should
therefore not be touched or removed unless explicitly stated otherwise:
– Ignition coils and caps
– Wires of the high voltage circuit
– In- and output wiring of the ignition controller
– Pickups and their wiring
Danger to persons with pacemakers!
Electromagnetic impulses in the wiring of the ignition system may exceed
the permissible limits of pacemakers. Persons with pacemakers must
therefore not be present in the vicinity of the ignition system being
operated. Mark the operating location of the ignition system with the
corresponding standardized warning symbol.
MOTORTECH equipment is manufactured as state of the art and therefore safe and reliable to
operate. Nevertheless the equipment can cause risks or damages can occur, if the following
instructions are not complied with:
– The gas engine must only be operated by trained and authorized personnel.
– Operate the equipment only within the parameters specified in the technical data.
– Use the equipment correctly and for its intended use only.
– Never apply force.
– For all work, such as installation, conversion, adaptation, maintenance, and repair, all
equipment must be disconnected from the power supply and secured against unintentional
restarting.
– Perform only such maintenance and repair work as is described in this operating manual,
and follow the instructions given while working. For maintenance of the equipment, only use
spare parts supplied by MOTORTECH. Further work must only be performed by personnel
authorized by MOTORTECH. Non-compliance with the instructions will void any warranties
for the proper function of the equipment as well as the responsibility for the validity of the
certifications.
– Safety devices must not be dismounted or disabled.
– Avoid all activities that can impair the function of the equipment.
2 SAFETY INSTRUCTIONS
To Next Page
Loading...
