Rev. 01/2015 71
8.2.3 Keys of the Control Panel
The following table gives an overview of the keys on the control panel and their functions.
Key Function
[ON/OFF] On/O
f ke
Key for switching the hand-held programmer on and off
[F1] to [F5] Function keys
Depending on the opened view, the function keys are assigned
differently. The respective assignment is shown in the corresponding
view.
[+/A] to ["/Y],
[ESC/Z]
Combination letter and character keys
Keys for entering letters and characters.
Without simultaneously pressing the shift key, the corresponding letter
is entered, e.g. "A" with the [+/A] key. If the shift key is pressed
simultaneously, the corresponding character above the letter is
entered, e.g. "+" with the [+/A] key. If the shift key is pressed with the
[ESC/Z] key, the ESC function is initiated (see functional description
below).
[0] to [9] Number keys
Numbers can be entered with these keys.
[CTRL] Control ke
Initiates the control functions of the hand-held programmer when
combined with other keys.
[ESC] Leave/open parameterization level
With this button, you close the currently opened view and return back to
main view.
In the main view, you open the parameterization level with this key.
[BACKSP] Backspace ke
Deletes the last character entered.
[SPACE] Space bar
Key for entering empty characters
[ENTER] Confirm
With this key, you confirm a selection or entry.
[SHIFT] Shift ke
Keys with dual functions will enter the upper character or initiate the
upper function if the shift key is held simultaneously.
To Next Page
Loading...
