Motortech MIC500 - Pickup Input Errors; Insufficient Power Supply; Exiting Error Status

10 ERRORS
112 Rev. 01/2015
10.2.3 Pickup Input Errors
The input signal from the pickup is faulty.
Potential causes:
– Number of teeth on the flywheel does not match the set number.
– Interference in the wiring of the pickup
– Wiring of the pickup incorrect
– Distance of the pickup incorrect
– Dirt on the pickup
10.2.4 Insufficient Power Supply
An error has occurred in the power supply to the MIC500.
Potential causes:
– The size of the power supply is too small
– Low battery
– Power supply wiring defective
– The power supply wiring is routed incorrectly
10.2.5 Exiting Error Status
Prior to exiting error status, ensure that the connected engine is not running.
The following options are available for exiting error status:
– Computer: briefly press [Shift]+[R]
– Hand-held programmer: briefly press [R]
– Disconnecting the supply voltage at the MIC500