8 ADJUSTMENTS
74 Rev. 01/2015
Following statuses are possible:
– READY
The ignition controller is ready for operation.
– FIRING
The ignition controller is firing.
– NO MPU
No input signal detected.
– TOO SLOW
The speed is too slow (less than 60 crankshaft revolutions or 30 camshaft
revolutions). This can be caused by an incorrect sequence number, a wrong trigger
disc or a weak pickup signal.
– WAIT FOR 0
The ignition controller is waiting for engine standstill.
– SECURITY ON
The Start/Stop input is closed.
– OVERSPEED ERR
The defined overspeed level was exceeded.
– CAM MPU ERROR
Errors with the pickup signal were detected.
– OUTPUT FAILURERATE EXCEEDS
The defined misfire rate for the indicated output was exceeded.
– LOW VOLTAGE
The supply voltage has fallen below 10 V.
– CHECKSUM ERR
A loss in voltage occurred in programming mode, which led to a failure. The unit
must be re-parameterized.
To Next Page
Loading...
