ioThinx 4510 Series Software Tools
Start Address Textbox: Change the value of the Start Address in the textbox (0 to 65535 or leave it
blank). When there is no value in the textbox, it will be displayed in light yellow. When it conflicts with
another register, it will be displayed in red. Revise the value to prevent address conflict. You can use the
Sort function to see where there is a conflict of addresses.
Sort: The default-sorted column is the Slot from the lowest to highest slot number. Click the green arrow to
change the sorting method. Click the gray arrows on the other columns to sort that specific column.
Enable/disable this service through
Security Service Settings.
In the event that a conflict address value is entered, whenever you click on a different point type
tab, the previous configurations will be restored to avoid the conflict.
Modbus/TCP Slave Rules for the available Modbus register.
To Next Page
Loading...
