NPort 5600-8-DT/DTL Series Basic Installation
In the Serial Parameters tab, adjust the settings to match your
device. These settings , used for serial printer only, must also
match the settings on the device port. Click “OK” when you are
satisfied with your changes.
For additional details on Advanced Settings in NPort
Administrator, please refer to Chapter
8.
In Hi-Performance mode, the driver immediately
issues a “Tx Empty” response to the program after sending
data to the NPort. In Classical mode, the driver sends the “Tx
Empty” response after confirmation is received from the NPort.
Classical mode is recommended if you want to ensure that all
data is sent out before further processing.
This tells the driver whether or not to use the FIFO.
Network Timeout: This specifies when an open, close, or serial
parameter change operation will time ou
t.
When enabled, the driver flushes only the local
buffer on the host for a Win32 PurgeComm() function call.
When disabled, both the local and remote buffers are flushed.
If your application uses PurgeComm() and performance seems
sluggish, try
enabling Fast Flush.
Apply Change
Right-click COM Mapping in the Function panel and select “Apply Change” in the context menu to save the
current COM mapping settings. Your application will now be able to access the target serial device using the
COM port.
To Next Page
Loading...
Need help?
General
