NPort 5600-8-DT/DTL Series Using NPort Administrator
Saving COM Mapping Settings
After mapping COM ports to NPort device ports, you will need to save the COM mapping settings to the Real
COM driver. Use the Apply Change command in the function context menu to save the mapping settings; use
the Discard Change command to delete the changes. Once COM mapping has been applied, the Real COM
driver will transparently connect the designated COM port to the device port. NPort Administrator is not needed
for Real COM operation. COM mapping will be effective whether or not NPort Administrator is open.
You can also save COM mapping settings to a text file, which can then be used to duplicate the COM mapping
on another host. Use the Export COM Mapping command in the function context menu to save the current
COM mapping settings. Use the Import COM Mapping command to load COM mapping settings from a
previously saved file.
To Next Page
Loading...
