NPort 5600-8-DT/DTL Series Using NPort Administrator
3. Once your device server is on the list for the desired function, right-click the target device server to open
the function context menu. Activate the desired command from this context menu. You may also select the
target device server and then open the function context menu from the menu bar.
Configuration
Select the Configuration function to configure your NPort, import and export its configuration, or update its
firmware.
Finding Your Device Server
If the list of available servers is empty, find your device server on the network using the Broadcast Search or
Specify by IP Address commands in the function context menu.
Broadcast Search: This searches for all NPort units on the LAN. Since this search is based on MAC address,
rather than IP address, it will be able to find units that are not on the same subnet as your PC. You may click
Stop as soon as your device server is found.
Specify by IP Address: This allows you to find your device server manually by entering its IP address.
To Next Page
Loading...
Need help?
General
