NPort 5600-8-DT/DTL Series General Settings
Overview
The NPort 5600-8-DT/DTL can be configured through NPort Administrator, the web console, the Telnet console,
or the serial console. For each of these configuration interfaces, parameters are organized by type. For this
chapter, screenshots from the web console are used to illustrate the available parameters, but the same
parameters can be modified using the other interfaces.
Basic Settings
Server name (default = blank): This is an optional free text field for your own use. It does not affect operation
of the NPort device server. It can be used to help differentiate one device server from another.
ATTENTION
There is a risk of explosion if the real
-time clock battery is replaced incorrectly!
The real time clock is powered by a lithium battery. We strongly recommend that you obtain assistance from
a Moxa support engineer before replacing the
battery. Please contact the Moxa RMA service team if you need
to change the battery.
Time zone (default = GMT Greenwich Mean Time): This field shows the currently selected time zone and
allows you to select a different time zone.
Local time: This field shows the time that you last opened or refreshed the browser, using the NPort’s built-in
real-time clock. You can adjust the real-time clock using this field. Make sure that you first select the correct
time zone.
Time server (default = blank): This optional field is for your time server’s IP address or domain name, if a time
server is used in your network. The NPort 5600-8-DT/DTL supports SNTP (RFC-1769) for automatic time
calibration. The device server will request time information from the specified time server every 10 minutes.
Web console (default = Enable): This field enables or disables access to the web console.
Serial console (default = Enable): This field enables or disables access to the serial console (applies to DTL
models only)
To Next Page
Loading...
Need help?
General
