MR TAPCON 250 - Setting the Device Time

9 Operation
Maschinenfabrik Reinhausen GmbH 2022 878595028/00 EN TAPCON
®
250
Be sure to enter a valid network mask that is not 0.0.0.0, otherwise it will not
be possible to connect to the device.
Gateway address
You can use this parameter to set the gateway's IP address.
If you set the value to 0.0.0.0, no gateway is used.
SSL/TLS encryption
You can use this parameter to set whether the process for accessing the vi-
sualization should be carried out over an SSL/TLS-encrypted connection.
TLS version
You can use this parameter to set the accepted TLS versions. If you would
like to establish an encrypted connection to the visualization, you must use
an accepted TLS version. You can select the following options:
Option Accepted TLS versions
>= 1.0 ▪ 1.0
▪ 1.1
▪ 1.2
>= 1.1 ▪ 1.1
▪ 1.2
>= 1.2
1)
▪ 1.2
Table15: TLS version
1)
This option can be selected only if the TLS version is supported by the
connected peripheral equipment.
9.1.3 Setting the device time
You can set the the device time manually or automatically via an SNTP time
server. The device must be connected to an SNTP time server via Ethernet
for this purpose.
1. Go to Settings > Parameters > System > Time synchronization.
2. Select the desired parameter.
3. Set the parameter.
4. Press the Accept button to save the modified parameter.