MR TAPCON 250 - Configuring Syslog

9 Operation
Maschinenfabrik Reinhausen GmbH 2022 898595028/00 EN TAPCON
®
250
1. Go to Settings > Parameters > System > Screensaver.
2. Select the desired parameter.
3. Set the parameter.
4. Press the Accept button to save the modified parameter.
Screensaver
If you activate this function, the device fully switches off the display when the
adjustable waiting period has expired if no key is pressed. The display
switches on again if you press any key.
Deactivating the screensaver has a negative impact on the service life of
the display. Maschinenfabrik Reinhausen recommends that you activate the
screensaver and set a waiting period of 15 minutes.
Screensaver waiting time
You can use this parameter to set the screensaver waiting time.
9.1.5 Configuring syslog
The device supports the transmission of log messages via the syslog proto-
col in accordance with the following standards
▪ RFC5425
▪ RFC3164
▪ RFC5426
▪ RFC6587
1. Go to Settings > Parameters > System > Syslog.
2. Select the desired parameter.
3. Set the parameter.
4. Press the Accept button to save the modified parameter.
Activate syslog
You can use this parameter to activate transmission of syslog messages via
the device.