MR TAPCON 250 - Setting the Screensaver

9 Operation
Maschinenfabrik Reinhausen GmbH 202288 8595028/00 ENTAPCON
®
250
Time synchronization via SNTP
You can use this parameter to activate time synchronization using an SNTP
time server.
SNTP time server
You can use this parameter to enter the IP address of a SNTP time server. If
you are using a time server, the device uses the time of the time server as
the system time.
Be sure to enter a valid time server address that is not 0.0.0.0, otherwise it
will not be possible to connect to the device.
Synchronization interval
You can use this parameter to set the interval at which the device is to call
up the time from the time server.
Time zone
To adjust the device time to your local time, you can use the time shift pa-
rameter to set the time shift to UTC.
Example:
Region Time shift to UTC
Mumbai, India UTC +5:30h
Beijing, China UTC +8:00h
Brasilia, Brazil UTC -3:00h
Table16: Time shift to UTC (Coordinated Universal Time)
Time
You can use this parameter to set the date and time manually.
SNTP time server 2
You can use this parameter to enter the IP address of the second time
server (optional).
9.1.4 Setting the screensaver
To increase the service life of the display on the front panel of the device,
you can activate and set a screensaver. The following functions are avail-
able for this purpose:
▪ Screensaver waiting time