Model 493.02 Controller Service
Index
247
service tools 231
application 232
initializing controller 235
setting passwords 240
updating system options 237
servovalve
adjust valve balance 75
adjusting dither amplitude 76
cable specifications 48
dither 72
I/O carrier connection 48
polarity check 103
valve balance 72
warmup 74
setting passwords 240
shunt calibration 89, 157
I/O carrier connector 92
procedure 89
shunt resistor connector 92
shunt resistor installation 158
shunt resistor table 90
when to use 89
signal polarity 97
specifications
sensor cables 86
servovalve cable 48
specimens 210
changing 192
tuning with 210
tuning without 211
spool position
zeroing
zero spool position 78
square wave shape 208
stabilizing
with acceleration feedback 205
with delta P feedback 204
stand alone configuration 20
strain control 197
system cables
analog I/O 53
part number list 45
system cables/jumpers 45
system cabling
automated 42
stand-alone 41
System I/O module connections 58
system options, updating 237
system software 23
options 24
system warm-up 97
T
Temposonics calibration
setting resolution 170
temposonics calibration
signal monitoring 169
Temposonics sensor calibration
calibration file 170
connections 167
defining an input 167
setting zero 172
Temposonics sensors 167
transducer cables
part numbers 87
specifications 86
transducer connections 83
tuning
about 192
auto tuning 217
checklist 194
compensation 192
control modes 196
control range adjust 199
controls 199
creating a program 207
displacement 215
force control modes 216
guidelines 193
innerloop 77
monitoring waveforms 211
pre-calibration, LVDT 100
prerequisites 195
proportional gain 200
selecting amplitude 209
selecting frequency 209
specimens
changing 192
tuning with 210
tuning without 211
waveforms 207
when to tune 194
V
valve balance adjustment 75
valves
polarity check 103
VMEbus modules
descriptions 28
installing 27
W
waveforms 207, 211
areas of interest 211
error signal 212
monitoring 211
workstation connection 56
To Next Page
Loading...
Need help?
General
