© Munters AB, 2020 80
determine the gain (refer to Calibration). This quantity is not related to the
actual batch quantity.
o
Clicking Test shows the following values:
Measured weight
Real time A/D
Error status
o
Calibrate the weigher. Refer to Batch Bin Calibration, page 83.
NOTE Once the bin capacity is defined, any change will require recalibrating the batch
weigher.
3. In System > Devices & Sensors > Installation > Scales define up to three relays as
Silos.
4. Define:
o
Storage Capacity: Define the capacity of the silo mapped to this auger (Silo
Auger 1 – Silo 1, etc.).
NOTE This parameter is hidden when Silo Weight is used to manage the feed inventory.
5. In System > Devices & Sensors > Installation, define up to three relays as Silo
Augers.
To Next Page
Loading...
