© Munters AB, 2020 81
6. Define:
o
Default Output: Define the relay’s default state, normally open or normally
closed.
o
Feed Per Minute: Define the amount of feed per minute that the silo auger
sends to the batch weigher.
o
Silo Capacity: Enter the silo’s capacity in kilograms or pounds. The controller
uses this value to manage the silo inventory.
7. In System > Devices & Sensors > Installation, define one digital port as Batch Hopper
Limit. This sensor (placed in the bin) stops feed delivery when the feed level reaches
the sensor.
8. Define the Active State.
o
Open: The circuit is open when the sensor is activated.
To Next Page
