Press [Resolution].
3
If [Resolution] is not displayed, press the [Advanced] tab and then select [Resolution].
Select the desired resolution, and press [Enter].
4
Specify the destination, and press <Start>.
5
For details on specifying the destination, refer to “• Selecting from the Address Book”. (See
page 5-2.)
If you loaded the document in the ADF, this concludes the procedure.•
If you loaded the document on the document glass, load the next document, and press •
[Next Doc]. Press [Tx Start] to start transmission.
The Super Fine mode may not be supported by the destination machine. In this •
case, the optimal resolution will be automatically selected.
The communication time differs according to the selected resolution.•
To Next Page
Loading...
Need help?
General
