40 Changing the Head Height
1 Advanced setting
If you use a roll media that warps easily or perform high-density print, the print head may contact the media while printing. If
you experience such problem, try changing the head height higher.
After you change the head height, make sure to perform the print quality calibration.
Changing the Head Height
Important!
Do not open Front cover and change the head height during printing.
Print quality cannot be guaranteed.
[1]
Open the front cover.
[2]
Use the head height adjustment lever (orange) to change the head
height to “Mid” or “High”.
• High: set the head height to High.
• Mid: set the head height between Low and High.
• Low: Default head height.
[3]
Close the front cover.
[4]
Perform print quality calibration.
"Print quality calibration" P. 35
To Next Page
Loading...
