Muton XPJ-1641SR - Setup 18: Exhaust Fan; Setup 19: Longstore; Setup 20: CR Maintenance

Setup 18: Exhaust Fan 87
Setup 18: Exhaust Fan
Sets up Exhaust fan operation.
Ventilates the inside of the printer to stabilize the parts performance. It also
decreases the contamination by ink mist inside the printer.
We recommend that you use Exhaust fan, especially when printing for a long
time.
Setting values
Turn Off Exhaust fan.
Start Exhaust fan at Low.
This is the initially set value.
Start Exhaust fan at High.
Setup 19: Longstore
Wash Print head with the cleaning fluid.
Submenu
Wash Print head with the cleaning fluid.
Tap [Enter] to perform head cleaning.
"Long-term storage" P. 138
Important!
Be sure to use the designated cleaning bag.
Setup 20: CR Maintenance
Performs maintenance. Used in the following cases.
• Cleaning and replacing of cleaning wiper
• Cleaning of print head circumference
• Replacing absorption material for the flushing box
• Replacing cutter
"Maintenance" P. 110
Submenus
Performs maintenance.
Completes maintenance.
Perform the pumping operation (start/
stop) by using .
Setup 18
Exhaust Fan
Exhaust Fan:
Off
Exhaust Fan:
Low
Exhaust Fan:
High
Setup 19
Longstore
Longstore
Start -> Enter
Setup 20
CR Maintenance
CR Maintenance
Start -> Enter
CR Maintenance
End -> Enter