90 Setup 26: Header Dump
Setup 26: Header Dump
Sets whether to print the following information when printing.
• Data header
• Data dot number (printed only when Header damp setting is “On”)
• Printing date and time
• Printer serial number
• Firmware version
• Receiving time (printed only when Header damp setting is “Dump”)
• Receiving size (printed only when Header damp setting is “Dump”)
Setting values
Dump data is not printed.
This is the initially set value.
Dump data is printed after the original
image is printed.
Prints only damp data.
“Data dot number” is not printed.
Prints the last header dump.
If no history is available, “No Print Data”
will appear on the front panel.
Note
• The data will be useful when contacting technical support.
• Performing printing if the printer is connected to PC, the print settings of RIP soft you are using are printed on data header.
Setup 27: Single Head (XPJ-1682SR Only)
Selects a print head for printing.（XPJ-1682SR Only）
You can still print even if some of the print heads malfunction. However, in that
case the printing speed will drop.
Setting values
Select this setting to use all the print
heads for printing.
This is the initially set value.
Select this setting to use only print head 1
for printing.
Select this setting to use only print head 2
for printing.
Important!
In case of any problems with the print heads, contact your local MUTOH dealer.
To Next Page
Loading...